Will “Wire Drawing Setter” be Replaced By Robots? 🤔

91% Chance of Automation

“Wire Drawing Setter” will probably be replaced by robots.

This job is ranked #560 out of #702. A higher ranking (i.e., a lower number) means the job is less likely to be replaced.

Care to share? Click for Facebook, Twitter, LinkedIn, or XING. 👍

Set up, operate, or tend machines to extrude or draw thermoplastic or metal materials into tubes, rods, hoses, wire, bars, or structural shapes.

☝️ Information based on the reference occupation “Extruding and Drawing Machine Setters, Operators, and Tenders, Metal and Plastic”.

Test physical properties of products with testing devices such as acid-bath testers, burst testers, and impact testers.
Change dies on extruding machines according to production line changes.
Start machines and set controls to regulate vacuum, air pressure, sizing rings, and temperature, and to synchronize speed of extrusion.
Clean work areas.
Determine setup procedures and select machine dies and parts, according to specifications.
Install dies, machine screws, and sizing rings on machines that extrude thermoplastic or metal materials.
Adjust controls to draw or press metal into specified shapes and diameters.
Replace worn dies when products vary from specifications.
Operate shearing mechanisms to cut rods to specified lengths.
Reel extruded products into rolls of specified lengths and weights.
Load machine hoppers with mixed materials, using augers, or stuff rolls of plastic dough into machine cylinders.
Measure and examine extruded products to locate defects and to check for conformance to specifications, adjusting controls as necessary to alter products.
Select nozzles, spacers, and wire guides, according to diameters and lengths of rods.
Weigh and mix pelletized, granular, or powdered thermoplastic materials and coloring pigments.
Troubleshoot, maintain, and make minor repairs to equipment.
Maintain an inventory of materials.